Fitment Information

This jack pad fits any uni-body vehicle with pinch welds at least 3 inches wide. The list below covers some of the most common compatible vehicles — it is not exhaustive. If your vehicle has a uni-body construction (as opposed to a body-on-frame design), this pad will almost certainly work.

Sample Fitment List (Non Exhaustive):

Acura Integra / RSX / TSX / TL
Audi A3 / A4 / A5 / S3 / S4 / TT / RS3
BMW 3 Series / 5 Series / M3 / Z3 / Z4
Chevrolet Camaro (2010+)
Chevrolet Cobalt SS
Dodge Neon SRT-4 / Caliber SRT-4
Ford Fiesta ST
Ford Focus / Focus ST / Focus RS
Ford Mustang (2005+)
Honda Accord (all generations)
Honda Civic (all generations)
Honda CR-V (all generations)
Honda S2000
Hyundai Genesis Coupe / Veloster N / Elantra N
Kia Forte / Optima / Stinger
Mazda Miata MX-5 (NA, NB, NC, ND)
Mazda 3 / 6 / RX-8 / MazdaSpeed 3
MINI Cooper (all generations)
Mitsubishi Eclipse / Lancer / Galant
Mitsubishi Evolution VII / VIII / IX / X
Nissan 240SX / 350Z / 370Z
Nissan GT-R (R32 / R33 / R34 / R35)
Nissan Sentra / Altima / Maxima
Porsche 911 / Boxster / Cayman (all generations)
Scion FR-S / tC / xB
Subaru BRZ (all generations)
Subaru Forester / Outback / Legacy / Impreza
Subaru WRX / STI (all generations)
Toyota Camry (all generations)
Toyota Celica
Toyota Corolla (all generations)
Toyota GR86 / Supra
Volkswagen Beetle / Golf / GTI / R / Jetta / Passat

Fitment Note: This pad requires a pinch weld flange of at least 3 inches to seat properly. It is not compatible with body-on-frame vehicles — this includes full-size trucks (F-150, Silverado, Ram 1500, etc.), traditional body-on-frame SUVs, and Jeep Wrangler/Gladiator. If you're unsure whether your vehicle is uni-body, check along the underside of the rocker panel — if you see a seam flange running the length of the car, you have pinch welds and this pad will work.

Product Specs

6061 Billet Aluminum
Black Anodized W/ Torque Solution logo
Fits all vehicles equipped with pinch welds
Limited Lifetime Warranty

Product Description

Torque Solution Pinch Weld Jack Pad is designed to fit the pinch weld on most uni-body vehicles. Use of our jack pad will help prevent damage to your vehicles pinch weld or rocker panel that can occur when using a hydraulic jack. NO MORE FLATTENED PINCH WELDS!!! Each Jack Pad is made from 6061 billet aluminum and anodized black for protection. It also comes pre-installed with 4 Neodymium magnets for holding strength while placing jack and lifting vehicle. The magnets are embedded into a nylon insert to help relieve pressure on the pinch weld. Our jack pad will fit most vehicles with pinch welds that are at least 3 inches.

Shop Supplies, Tools & Hardware

Torque Solution Universal Pinch Weld Jack Pad TS-TL-418